Underwater Installation Instructions
Recommendation
-
Installation work has to be carried on according to the enclosed installation manual of Unilamp.
-
Unilamp's underwater luminaire can install in both the chlorine pool and saltwater pool that is a salt concentration from 5,000 ppm – 50,000 ppm.
-
All mounting hardware, such as screws, must be made of 316 stainless steel to prevent corrosion which will cause damage to the underwater luminaire
➝ Before installation
-
Carefully check the dimension of the underwater luminaire and verify suitability of the installation location.
-
In case of installation of recessed underwater spotlights, verify that the installation housing and wall from a water tight assembly. It must be avoided that water can leak into the wall structure.
-
Keep the installation area and luminaire clean from debris during and after installation.
➝ After installation
-
Check the luminaires lens every six months for accumulation of dirt, algae or other kind of debris. Clean when necessary in order to maintain the light output.
-
Inspect the luminaire housing every six months for stains. Clean with appropriate tools and chemicals if necessary
Do:
-
Clean the outer surface of the luminaire with a damp microfiber towel or similar soft fabric.
-
If necessary use a suitable cleaner for the housing or lens. Follow the directions of the used cleaning product.
-
Follow the product specific directions in the installation manual. Most underwater luminaires must be submerged in water when operated.
Do not:
-
Do not use any tool that can scratch the underwater luminaire front frame.
-
Only use appropriate cleaners near or at the luminaire. Unsuitable cleaners will cause damage to rubber seals and corrode the housing. Consult the Unilamp after sales team for recommended cleaners.
-
Do not use a high water pressure (power washer) at the luminaire. High water pressure will damage the underwater luminaire.
